Toilet overflowing: stop it in under a minute
Do these in order.
Push the flapper down into its seat to stop water entering the bowl.
Turn the oval handle behind the toilet clockwise until it stops.
Another flush on a blocked toilet sends more water to the floor.
If the water keeps rising after the valve is shut, the problem is a main line blockage. See drain cleaning.
What your toilet is telling you
| Symptom | Usual cause | Typical fix |
|---|---|---|
| Runs after flushing | Worn flapper or fill valve | Replace the parts. |
| Weak flush | Clogged rim jets or low tank water level | Clean jets and adjust the level. |
| Water around the base | Failed wax ring or loose bolts | Reset the toilet with a new seal. |
| Rocks when you sit | Loose flange bolts or uneven floor | Tighten and shim, or reset. |
| Clogs often | Partial blockage deeper in the line, or an old low-flow design | Auger or camera the line, or replace the toilet. |
| Water on the floor from the tank | Cracked tank or failed tank bolt gaskets | Replace gaskets or the tank. |
Gurgling in the toilet when another fixture drains points to the drain line, not the toilet.
Repair or replace: how we decide
A toilet is worth repairing when the porcelain is sound and the parts are standard. A flapper, fill valve or wax ring is a short job and the toilet lasts years longer. Replacement makes sense when the bowl or tank is cracked, when the toilet is an older high-volume model that still clogs, or when repeated repairs add up.
California limits new toilets to 1.28 gallons per flush through its plumbing code, so a modern replacement uses far less water than a pre-1990s model. We tell you what we see and let you choose.
Toilet giving you trouble?
Call and describe what it does. We will tell you what to expect.
How a toilet installation goes
Shut off and drain
We close the supply, empty the tank and bowl and disconnect the supply line.
Pull and inspect
The old toilet comes up and we check the flange and the floor for rot or damage.
Set the new unit
A new wax ring or seal, new bolts and a level fit.
Test
We flush several times, check every joint for seepage and caulk the base if you want it.
When the toilet is not the problem
If several fixtures drain slowly, if a tub gurgles when the toilet flushes or if the toilet backs up when the washer runs, the blockage is in the branch or main drain. A new toilet will not fix that. We check before replacing anything, because a camera look costs less than the wrong replacement. See sewer camera inspection.
A toilet that leaks at the base for a long time can rot the subfloor. If we find soft flooring we show you before covering it.
What affects toilet repair and installation cost
A price before work starts.
Standards behind the work
The 1.28 gallon per flush limit for new toilets comes from California plumbing rules built on the California Plumbing Code, which is based on the Uniform Plumbing Code (UPC). According to the City of Milpitas Office of Building Safety, repairs that do not replace pipe need no permit.
Common Questions
Yes, our line is open 24 hours. Shut the valve behind the toilet first, then call.
Most often the flapper no longer seals or the fill valve is worn. Both are quick repairs.
Yes. Tell us the model and we check that it fits your rough-in distance before we arrive.
Most take about an hour once the old one is out and the flange is sound.
Yes. Haul-away is part of the service when you ask for it.
