Meter to house: which pipe this page covers
The city says its water service line permit covers replacing the existing service piping between the meter and the building. It is not the permit for adding a brand new service with a new city meter. Pipe inside the house is a different job, covered under repiping.
If you cannot tell whether a leak is on the city side or your side of the meter, call Public Works at (408) 586-2600 during business hours before you dig. After hours the city lists (408) 586-2400.
Signs of a failing service line
Meter runs with the house shut off
The test is to close the main at the house and see if the meter still spins.
Wet or soft ground
Water bubbling from the ground or a patch of green grass in dry season.
Low pressure throughout
A leak or a partly collapsed pipe reduces flow to every fixture.
Discolored water
Old galvanized or corroded pipe flaking inside.
High bill with no change in use
A buried leak runs 24 hours a day.
Sound of running water at the meter
A hiss near the meter or the house wall.
What the city handout requires for a water service line
- A permitIt may be issued to a licensed contractor with the proper classification or to the homeowner. If the homeowner or their workers fail inspection, a licensed contractor must finish the job.
- Approved pipeBrass, copper, CPVC, PEX, PE-RT, stainless steel and others, all lead-free and rated NSF 61. The service must be at least 3/4 inch, and copper must be at least Type L.
- Depth and beddingYard piping must be at least 12 inches below finished grade, on a firm bed, with clean backfill 12 inches above the pipe.
- Tracer wire and sleevesPlastic service pipe outdoors needs an 18 AWG blue insulated copper tracer wire, and PEX in soil must be sleeved.
- Shutoff valveA fullway shutoff valve must sit on the discharge side of the meter and stay accessible.
- Test and inspectThe pipe must hold pressure for at least 15 minutes. A rough inspection happens before the trench is covered and a final follows. Permits expire 180 days after issuance or the last passed inspection.
Water bubbling in the yard?
Close the main valve at the house and call. The line is open 24/7.
Repair or replace the service line
| Situation | Likely answer | Why |
|---|---|---|
| One leak on newer pipe | Spot repair | The pipe is otherwise sound. |
| Repeat leaks on older copper or galvanized | Replace the line | More failures are likely. |
| Pipe is shallow or crushed | Replace with correct depth and bedding | City handout requires 12 inches. |
| Low pressure only, no leak | Check pressure regulator and valves first | The line may be fine. |
| Pipe crosses a sewer or drain trench | Raise and shelf the water pipe | City rule keeps water pipe 12 inches above a clay or non-approved sewer line. |
Low pressure in Milpitas homes is not always the line
Low pressure can come from a stuck pressure regulator, a half-closed valve, clogged fixture screens or a partly failed service line. We test pressure with a gauge at a hose bib to see whether the problem is the supply or the house.
The California Plumbing Code in the city handout calls for a pressure regulator where pressure exceeds 80 psi. A regulator that fails open pushes pressure above that, and one that fails closed gives you a trickle. A pressure test costs far less than digging the yard.
What affects the price of water line work
You get a price before work.
Sources for the service line rules
Depth, pipe material, tracer wire and inspection rules on this page are taken from the City of Milpitas water service line permit handout. It cites the California Plumbing Code, which is based on the Uniform Plumbing Code (UPC) and requires products certified to NSF/ANSI/CAN 61.
Common Questions
Yes. Close the main valve at the house and call. If the leak is on the city side of the meter, we help you report it to the city.
The city's permit handout covers replacing service piping between the meter and the building, which indicates that portion is the property owner's to maintain. Confirm with Public Works at (408) 586-2600.
The city handout states yard piping must be at least 12 inches below finished grade.
Yes. The city says replacing existing service piping between the meter and the building needs a plumbing permit and two inspections.
Sometimes, with trenchless methods or by running the new line along the old path. We check the layout and the city rules first.
