When a pipe bursts: the first ten minutes
The order matters. Water first, then electricity, then belongings.
Find the main valve at the house, often near the front hose bib, and turn it clockwise. If you cannot reach it, the city-side valve is near the meter.
If water is near outlets, ceiling fixtures or appliances, shut off those circuits at the panel before stepping into standing water.
This drains the line and lowers pressure. Flush a toilet once to empty the tank.
Call us, then photograph the damage and the broken pipe for any insurance claim.
Milpitas Public Works answers water emergencies on the city side of the meter at (408) 586-2600 during business hours and (408) 586-2400 after hours.
Why pipes burst in a mild climate like Milpitas
Hard freezes are rare in Milpitas, so most bursts come from other causes. High water pressure is a big one. The California Plumbing Code, in the city's handout, calls for a pressure regulator when pressure exceeds 80 psi, and a failed regulator can push pipes past their limit.
Corrosion, a failing joint and ground movement after an earthquake are the other common causes. A rare cold snap can freeze an exposed hose bib line or a pipe in an unheated attic or garage wall.
Pipes we repair
- Copper supply linesPinholes from corrosion and failed solder joints in homes built from the 1960s through the 1980s.
- PEX and CPVCFailed fittings, damaged runs and rodent chew marks. PEX in soil must be sleeved under the city handout.
- Galvanized steelOld galvanized pipe corrodes from the inside and bursts at threads. A repipe is often the better outcome.
- Drain and sewer linesA cracked drain can flood a wall cavity. For lateral breaks see sewer line repair.
- Hose bibs and supply stopsSmall failures that run all night in a wall or garage.
Water pouring from a pipe?
Close the main valve first, then call. We answer all night.
Temporary fix and permanent repair
| Stage | What we do | Why |
|---|---|---|
| Stop the water | Isolate the section with a local valve or cap | Stops damage fast. |
| Find the extent | Check the nearby pipe for the same corrosion | One burst often points to more weak pipe. |
| Cut out and replace | Remove the failed section, install new pipe with approved fittings | Permanent repair. |
| Test | Pressure test and check for leaks | City handout expects a pressure hold for at least 15 minutes on water piping. |
| Advise | Explain what to check on drying and damage | Water damage follows the burst. |
After the pipe is fixed: drying and damage
We repair plumbing, not water damage restoration. After the pipe is fixed, wet drywall, insulation and flooring may need professional drying. Ask your insurer whether they have a preferred restoration company, and photograph everything before cleanup.
If you also suspect water in the walls, we can verify with leak detection before the walls are closed up.
What drives burst pipe repair cost
A clear price before work begins.
Sources for the rules on this page
The 80 psi regulator threshold comes from the City of Milpitas Office of Building Safety handout. The pressure-test rule comes from the same source, which is built on the California Plumbing Code, which is based on the Uniform Plumbing Code (UPC).
Common Questions
Yes. The line is open 24/7. Close the main valve and call, and we send the next available plumber.
Usually at the house, near the front hose bib, in the garage or by the water heater. There is also a valve at the meter box. Learn where yours is today.
Often the sudden water damage is, and the pipe itself may not be. Policies vary, so call your agent and keep receipts.
Not always. One burst on newer pipe is a one-off. Repeated failures on galvanized or old copper point to a repipe.
You can stop the water and drain the line. Do not solder or glue a pipe that is wet, and do not touch wet electrical areas.
